mixes with air and water to flow rapidly down slope.The upper part of  dịch - mixes with air and water to flow rapidly down slope.The upper part of  Việt làm thế nào để nói

mixes with air and water to flow ra

mixes with air and water to flow rapidly down slope.
The upper part of the flow is often confined to a channel
or valley but may spread out when it is no longer confined. A debris flow has less than 50 percent fines (sand,
silt, and clay), whereas a mud flow has more than 50 percent fines by volume. A debris avalanche (Figure 7.3i) is a
very rapid to extremely rapid debris flow. Large debris
avalanches can cause catastrophic damage and loss of life.
Lateral spreads (Figure 7.3j) are a type of landslide that
often occurs on nearly flat slopes or very gentle slopes.
The movement starts with liquefaction of silts, clays, or
fine sands during earthquake shaking or other disturbances. The actual movement is lateral extension. If
stronger coherent rock or soil is at the surface and is over
a soil layer that liquefies, the stronger material may fracture, translate, rotate, or disintegrate and flow. Lateral
spreads often start suddenly and then become larger, in a
Subsidence may occur on 1 slower, progressive manner.
slopes or on flat ground and involves the sinking of a mass
of earth material below the level of the surrounding surface (Figure 7.3k).
Landslides are commonly complex combinations
of sliding and flowage. As an example, Figure 7.3l and Figthat is slump ure 7.6 show failures consisting of an upper
transformed to a flow in the lower part of the slide. Such
complex landslides may form when water-saturated Earth
materials flow from the lower part of the slope, undermining the upper part and causing slumping of blocks of earth
materials.
Important variables in classifying downslope movements are the type of movement (slide, fall, flow, slump,
or complex movement), slope material type, amount of
water present, and rate of movement. In general, the
movement is considered rapid if it can be discerned with
the naked eye; otherwise, it is classified as slow (Figure 7.3).
Actual rates vary from a slow creep of a few millimeters or
centimeters per year to very rapid, ranging from 1.5 m
(5 ft) per day, to extremely rapid, at 30 m (98 ft) or more
3 per second
0/5000
Từ: -
Sang: -
Kết quả (Việt) 1: [Sao chép]
Sao chép!
mixes with air and water to flow rapidly down slope.
The upper part of the flow is often confined to a channel
or valley but may spread out when it is no longer confined. A debris flow has less than 50 percent fines (sand,
silt, and clay), whereas a mud flow has more than 50 percent fines by volume. A debris avalanche (Figure 7.3i) is a
very rapid to extremely rapid debris flow. Large debris
avalanches can cause catastrophic damage and loss of life.
Lateral spreads (Figure 7.3j) are a type of landslide that
often occurs on nearly flat slopes or very gentle slopes.
The movement starts with liquefaction of silts, clays, or
fine sands during earthquake shaking or other disturbances. The actual movement is lateral extension. If
stronger coherent rock or soil is at the surface and is over
a soil layer that liquefies, the stronger material may fracture, translate, rotate, or disintegrate and flow. Lateral
spreads often start suddenly and then become larger, in a
Subsidence may occur on 1 slower, progressive manner.
slopes or on flat ground and involves the sinking of a mass
of earth material below the level of the surrounding surface (Figure 7.3k).
Landslides are commonly complex combinations
of sliding and flowage. As an example, Figure 7.3l and Figthat is slump ure 7.6 show failures consisting of an upper
transformed to a flow in the lower part of the slide. Such
complex landslides may form when water-saturated Earth
materials flow from the lower part of the slope, undermining the upper part and causing slumping of blocks of earth
materials.
Important variables in classifying downslope movements are the type of movement (slide, fall, flow, slump,
or complex movement), slope material type, amount of
water present, and rate of movement. In general, the
movement is considered rapid if it can be discerned with
the naked eye; otherwise, it is classified as slow (Figure 7.3).
Actual rates vary from a slow creep of a few millimeters or
centimeters per year to very rapid, ranging from 1.5 m
(5 ft) per day, to extremely rapid, at 30 m (98 ft) or more
3 per second
đang được dịch, vui lòng đợi..
Kết quả (Việt) 2:[Sao chép]
Sao chép!
trộn lẫn với không khí và nước chảy nhanh xuống dốc.
Phần trên của dòng chảy thường được giới hạn trong một kênh
hay thung lũng, nhưng có thể lan tỏa ra khi nó không còn bị giới hạn. Một dòng chảy các mảnh vỡ có ít hơn 50 phần trăm tiền phạt (cát,
bùn và đất sét), trong khi một dòng chảy bùn có hơn 50 phần trăm tiền phạt theo thể tích. Một trận tuyết lở mảnh vỡ (Hình 7.3i) là một
dòng chảy các mảnh vỡ rất nhanh rất nhanh chóng để. Mảnh vỡ lớn
tuyết lở có thể gây thiệt hại nghiêm trọng và mất mát của cuộc sống.
phết bên (Hình 7.3j) là một loại vang dội mà
thường xảy ra trên sườn núi gần như bằng phẳng hoặc độ dốc rất nhẹ nhàng.
Các phong trào bắt đầu với sự hóa lỏng của bùn, đất sét, hoặc
cát mịn trong trận động đất rung hoặc rối loạn khác. Các phong trào thực tế là phần mở rộng bên. Nếu
đá mạch lạc mạnh hơn hoặc đất ở bề mặt và đã qua
một lớp đất mà hóa lỏng, vật liệu mạnh có thể gãy xương, dịch, xoay, hoặc tan rã và dòng chảy. Lateral
lây lan thường bắt đầu đột ngột và sau đó trở nên lớn hơn, trong một
đất lún có thể xảy ra trên 1 chậm hơn, cách tiến bộ.
dốc hoặc trên mặt đất bằng phẳng và liên quan đến vụ đắm tàu của một khối lượng
vật liệu đất dưới mức của các bề mặt xung quanh (Hình 7.3k).
Lở đất là sự kết hợp thường phức tạp
trượt và flowage. Như một ví dụ, hình 7.3l và Figthat là sụt giảm ure 7.6 cho thấy thất bại bao gồm một trên
chuyển thành một dòng chảy ở phần dưới của slide. Như
lở đất phức tạp có thể hình thành khi Trái đất bão hòa nước
vật liệu chảy từ phần dưới của sườn dốc, phá hoại một phần trên và gây sụt giảm của khối đất
nguyên liệu.
biến quan trọng trong việc phân loại các phong trào downslope là kiểu di chuyển (trượt, mùa thu, dòng chảy , độ sụt,
hoặc chuyển động phức tạp), độ dốc loại vật liệu, lượng
nước mặt, và tốc độ di chuyển. Nói chung, các
phong trào được coi là nhanh chóng nếu nó có thể được phân biệt với
mắt thường; nếu không, nó được phân loại là chậm (Hình 7.3).
Tỷ lệ thực tế khác nhau từ một creep chậm của một vài mm hoặc
cm mỗi năm đến rất nhanh chóng, từ 1,5 m
(5 ft) mỗi ngày, cực kỳ nhanh chóng, tại 30 m ( 98 ft) hoặc nhiều hơn
3 mỗi giây
đang được dịch, vui lòng đợi..
 
Các ngôn ngữ khác
Hỗ trợ công cụ dịch thuật: Albania, Amharic, Anh, Armenia, Azerbaijan, Ba Lan, Ba Tư, Bantu, Basque, Belarus, Bengal, Bosnia, Bulgaria, Bồ Đào Nha, Catalan, Cebuano, Chichewa, Corsi, Creole (Haiti), Croatia, Do Thái, Estonia, Filipino, Frisia, Gael Scotland, Galicia, George, Gujarat, Hausa, Hawaii, Hindi, Hmong, Hungary, Hy Lạp, Hà Lan, Hà Lan (Nam Phi), Hàn, Iceland, Igbo, Ireland, Java, Kannada, Kazakh, Khmer, Kinyarwanda, Klingon, Kurd, Kyrgyz, Latinh, Latvia, Litva, Luxembourg, Lào, Macedonia, Malagasy, Malayalam, Malta, Maori, Marathi, Myanmar, Mã Lai, Mông Cổ, Na Uy, Nepal, Nga, Nhật, Odia (Oriya), Pashto, Pháp, Phát hiện ngôn ngữ, Phần Lan, Punjab, Quốc tế ngữ, Rumani, Samoa, Serbia, Sesotho, Shona, Sindhi, Sinhala, Slovak, Slovenia, Somali, Sunda, Swahili, Séc, Tajik, Tamil, Tatar, Telugu, Thái, Thổ Nhĩ Kỳ, Thụy Điển, Tiếng Indonesia, Tiếng Ý, Trung, Trung (Phồn thể), Turkmen, Tây Ban Nha, Ukraina, Urdu, Uyghur, Uzbek, Việt, Xứ Wales, Yiddish, Yoruba, Zulu, Đan Mạch, Đức, Ả Rập, dịch ngôn ngữ.

Copyright ©2024 I Love Translation. All reserved.

E-mail: