Part 1: Connect to the CloudStep 1: Connect the cloud to Router0.a. At the bottom left, click the orange lightning icon to open the available Connections.b. Choose the correct cable to connect Router0 Fa0/0 to Cloud Eth6. Cloud is a type of switch, so use a Copper Straight-Through connection. If you attached the correct cable, the link lights on the cable turn green.Step 2: Connect the cloud to Cable Modem.Choose the correct cable to connect Cloud Coax7 to Modem Port0.If you attached the correct cable, the link lights on the cable turn green.Part 2: Connect Router0Step 1: Connect Router0 to Router1.Choose the correct cable to connect Router0 Ser0/0/0 to Router1 Ser0/0. Use one of the available Serial cables.If you attached the correct cable, the link lights on the cable turn green.Step 2: Connect Router0 to netacad.pka.Choose the correct cable to connect Router0 Fa0/1 to netacad.pka Fa0. Routers and computers traditionally use the same wires to transmit (1 and 2) and receive (3 and 6). The correct cable to choose consists of these crossed wires. Although many NICs can now autosense which pair is used to transmit and receive, Router0 and netacad.pka do not have autosensing NICs.If you attached the correct cable, the link lights on the cable turn green.Step 3: Connect Router0 to the Configuration Terminal.Choose the correct cable to connect Router0 Console to Configuration Terminal RS232. This cable does not provide network access to Configuration Terminal, but allows you to configure Router0 through its terminal.
If you attached the correct cable, the link lights on the cable turn black.
đang được dịch, vui lòng đợi..
