Models with microprocessor control

Models with microprocessor control and digital
display.
1. Mains switch with “ON” indicator.
2. Temperature mode indicator.
3. Time mode indicator.
4. Display for temperature and time.
5. Operating, “RUN” mode.
6. Delay time state indicator.
7. Push button temperature selector.
8. Push button time selector.
9. Push button “increase” value or parameter.
10. Push button “decrease” value or parameter.
11. Push button Start / Stop.
12. Set temperature.
13. Set run time: time period from 1 minute to 9 hours
59 minutes, or up to 99.9 hours, once the set temperature
value has been reached.
14. Set wait time before starting the run, time period
from: 1 to 24 hours.
1
16
15
2
3
4
7
8
9
5
6
11
10
12
13
14
888
MODEL SUMMARY TABLE
Models CONTERM DIGITHEAT DIGITRONIC INCUBAT INCUDIGIT
TYPE Drying Oven Drying Oven Universal Bacteriological Incubator Bacteriological Incubator
CONTROL Temperature Temperature + time Temperature + time Temperature Temperature + time
DISPLAY Analogue Digital Digital Analogue Digital
AIR Convection Convection Fan assisted Convection Convection
CIRCULATION natural natural natural natural
CAPACITY LITRES 19 - 36 - 52 - 80 - 150 19 - 36 - 52 - 80 - 150 33 - 47 - 76 - 145 19 - 36 - 52 - 80 - 150 19 - 36 - 52 - 80 - 150
ACCESSORIES
Part No.
2000002Timer switch 0-120 minutes.
Suitable for CONTERM.
2000003 Timer switch 0-12 hours.
Suitable for CONTERMand INCUBAT.
200000924 hour programmer with continuous on/off
cycling up to every 15 minutes.
Suitable for CONTERMand INCUBAT.
Part No.
2000016 Digital printer for time and temperature
with numerical printout on continuous paper roll, with
print intervals from 1 minute to 99 hours.
Suitable for DIGITHEAT, DIGITRONIC and INCUDIGIT.
2000007 Digital programmable microprocessor.
Capacity: 10 programs of 100 segments. Programmable timer:
up to 99 hours 59’ 59’’. Program repitition: up to
99 times. Programs can also be linked for up to 4 stages.
RS-232 interface for data down load to a printer or
computer.
Suitable for DIGITRONIC.
15. RS-232 Interface output for a computer, printer or USB adapter.
16. Controllable safety thermostat (that disconnects power to the heater in case of a fault in microprocessor), manual
reset and function signal lamp.