Subsequent steps for verifying reinforcement of an RC element should be performed in the reinforcement calculation module:Define loads.Run calculations / reinforcement verification (reinforcement of an RC structure element should be calculated).The reinforcement satisfies all code conditions - it is necessary to check results of verification in the Robot module dedicated to calculations / code verification.The reinforcement is insufficient - calculation errors display in a dialog, which also presents a safety coefficient as the ratio of the resistance to the current value.View results or generate a report after verification of reinforcement.If reinforcement does not satisfy the requirements, activate the design mode in Robot using the Results > Freeze Reinforcement option. Robot then calculates reinforcement and generates reinforcement for the element. The generated reinforcement can be loaded into Revit if it is identical with the initial reinforcement that undergoes verification and exists in Revit.
đang được dịch, vui lòng đợi..